Difference between revisions of "Msc2G7:Joint assembly"

Revision as of 14:40, 24 June 2015 (view source) Veronika Laszlo (Talk | contribs) (→‎Step 5) ← Older edit		Revision as of 14:40, 24 June 2015 (view source) Veronika Laszlo (Talk | contribs) (→‎Step 1,2,3,4) Newer edit →
Line 78:		Line 78:
	===Step 1,2,3,4===		===Step 1,2,3,4===
		+
		+	[[File:Assembly U1.png]]

---

Revision as of 14:40, 24 June 2015

Joint assembly

Lower assembly

Step 1

Step 2

Hold the messing and plastic gear aligned with the bearings. The plastic gear held on top.

Step 3

Slide the axle through the bearing-gear-bearing sandwich, while watching the alignment of the gap.

Step 4

?????

Step 5

When the gap and the little black screw in the messing gear are aligned fasten the screw

Step 6

Put the biggest plastic gear on the potmeter of the ‘down servo’

Step 7

Slide that into the slot on the side

Step 8

Slide in the servo and bolt it down

Upper assembly

Step 8

Step 6,7

File:Assembly U6.png

Step 5

Step 1,2,3,4